Dr. Chiradeep Ghosh
My Social Links

Dr. Chiradeep Ghosh

Principal Researcher
Tata Steel Limited, India

Highest Degree
Ph.D. in Material Engineering from McGill University, Canada

Share this Profile

Area of Interest:

Physical Science Engineering
100%
Thermomechanical Controlled
62%
Characterization Materials
90%
Phase Transformation
75%
Electron Microscopy
55%

Research Publications in Numbers

Books
0
Chapters
0
Articles
0
Abstracts
0

Selected Publications

  1. Roy, U. and C. Ghosh, 2016. Residual stress analysis in galvannealed coating. Ironmaking Steelmaking, 43: 465-472.
    CrossRef  |  Direct Link  |  
  2. Ghosh, C., C. Aranas and J.J. Jonas, 2016. Dynamic transformation of deformed austenite at temperatures above the Ae3. Progr. Mater. Sci., 82: 151-233.
    CrossRef  |  Direct Link  |  
  3. Ghosh, C. and M. Shome, 2016. Dynamic strain aging during wire drawing and its effect on electrochemical behaviour. Ironmaking Steelmaking, (In Press). 10.1080/03019233.2016.1240840.
    CrossRef  |  Direct Link  |  
  4. Jonas, J.J., F. Montheillet, L.S. Toth and C. Ghosh, 2014. Effects of varying twist and twist rate sensitivities on the interpretation of torsion testing data. Mater. Sci. Eng.: A, 591: 9-17.
    CrossRef  |  Direct Link  |  
  5. Jonas, J.J., C. Ghosh and L.S. Toth, 2014. The equivalent strain in high pressure torsion. Mater. Sci. Eng.: A, 607: 530-535.
    CrossRef  |  Direct Link  |  
  6. Jonas, J.J., C. Aranas, V.V. Basabe and C. Ghosh, 2014. Dynamic transformation during the torsion simulation of strip rolling. Mater. Sci. Forum, 783-786: 39-44.
    CrossRef  |  Direct Link  |  
  7. Ghosh, C., V.V. Basabe and J.J. Jonas, 2014. Thermodynamics of dynamic transformation of hot deformed austenite in four steels of increasing carbon contents. Mater. Sci. Eng.: A, 591: 173-182.
    CrossRef  |  Direct Link  |  
  8. Basabe, V.V., J.J. Jonas and C. Ghosh, 2014. Formation of Widmanstatten ferrite in a 0.036% Nb low carbon steel at temperatures above the Ae3. Steel Res. Int., 85: 8-15.
    CrossRef  |  Direct Link  |  
  9. Jonas, J.J., C. Ghosh, X. Quelennec and V.V. Basabe, 2013. The critical strain for dynamic transformation in hot deformed austenite. ISIJ Int., 53: 145-151.
    CrossRef  |  Direct Link  |  
  10. Jonas, J.J., C. Ghosh, X. Quelennec and V.V. Basabe, 2013. Predicting the occurrence of dynamic transformation and rolling mill loads drops by hot torsion and compression testing. Int. J. Metall. Eng., 2: 1-9.
    CrossRef  |  Direct Link  |  
  11. Jonas, J.J., C. Ghosh and V.V. Basabe, 2013. Effect of dynamic transformation on the mean flow stress. Steel Res. Int., 84: 253-258.
    CrossRef  |  Direct Link  |  
  12. Jonas, J.J., C. Ghosh and V.V. Basabe, 2013. Dynamic transformation during simulated hot rolling. Mater. Sci. Forum, 762: 1-8.
    CrossRef  |  Direct Link  |  
  13. Jonas, J.J. and C. Ghosh, 2013. Role of mechanical activation in the dynamic transformation of austenite. Acta Mater., 61: 6125-6131.
    CrossRef  |  Direct Link  |  
  14. Ghosh, C., V.V. Basabe, J.J. Jonas, Y.M. Kim, I.H. Jung and S. Yue, 2013. The dynamic transformation of deformed austenite at temperatures above the Ae3. Acta Mater., 61: 2348-2362.
    CrossRef  |  Direct Link  |  
  15. Ghosh, C., V.V. Basabe, J.J. Jonas, S. Yue and X.Y. Xiong, 2013. Dynamic transformation behavior of a deformed high carbon steel at temperatures above the Ae3. ISIJ Int., 53: 900-908.
    CrossRef  |  Direct Link  |  
  16. Ghosh, C., V.V. Basabe and J.J. Jonas, 2013. Determination of the critical strains for the initiation of dynamic transformation and dynamic recrystallization in four steels of increasing carbon contents. Steel Res. Int., 84: 490-494.
    CrossRef  |  Direct Link  |  
  17. Basabe, V.V., J.J. Jonas and C. Ghosh, 2013. Formation of strain-induced ferrite in low carbon steels at temperatures above the Ae3. ISIJ Int., 53: 2233-2241.
    CrossRef  |  Direct Link  |  
  18. Shrivastava, S., C. Ghosh and J.J. Jonas, 2012. A comparison of the von Mises and Hencky equivalent strains for use in simple shear experiments. Philos. Mag., 92: 779-786.
    CrossRef  |  Direct Link  |  
  19. Jonas, J.J., V.V. Basabe and C. Ghosh, 2012. Transformation of deformed austenite at temperatures above the Ae3. Mater. Sci. Forum, 706-709: 2740-2745.
    CrossRef  |  Direct Link  |  
  20. Jonas, J.J., C. Ghosh, V. Basabe and S. Shrivastava, 2012. The Hencky equivalent strain and its inapplicability to the interpretation of torsion testing experiments. Philos. Mag., 92: 2313-2328.
    CrossRef  |  Direct Link  |  
  21. Basabe, V.V., J.J. Jonas and C. Ghosh, 2012. Formation of deformation-induced divorced eutectoid Pearlite above the Ae1. Adv. Mater. Res., 409: 829-834.
    CrossRef  |  Direct Link  |  
  22. Ray, R.K., B. Hutchinson and C. Ghosh, 2011. 'Back‐annealing' of cold rolled steels through recovery and/or partial recrystallisation. Int. Mater. Rev., 56: 73-97.
    CrossRef  |  Direct Link  |  
  23. Prasad, B., C. Ghosh, A. Chakraborty, N. Bandyopadhyay and R.K. Ray, 2011. Adsorption of arsenite (As3+) on nano-sized Fe2O3 waste powder from the steel industry. Desalination, 274: 105-112.
    CrossRef  |  Direct Link  |  
  24. Jonas, J.J., C. Ghosh and S. Shrivastava, 2011. Problems with using the Hencky equivalent strain in simple shear. Mater. Trans., 52: 1748-1751.
    CrossRef  |  Direct Link  |  
  25. Prasad, B., C. Ghosh and N. Bandyopadhyay, 2010. Removal of arsenic from arsenic contaminated water using integrated steel industry CRM fines. Tata Search, 1: 1-5.
  26. Ghosh, P., C. Ghosh and R.K. Ray, 2010. Thermodynamics of precipitation and textural development in batch-annealed interstitial-free high-strength steels. Acta Mater., 58: 3842-3850.
    CrossRef  |  Direct Link  |  
  27. Ghosh, C., A. Haldar, P. Ghosh and R.K. Ray, 2010. Microstructure, texture, grain boundary characteristics and mechanical properties of a cold rolled and annealed ferrite-bainite dual phase steel. Int. J. Mater. Res., 101: 1252-1263.
    CrossRef  |  Direct Link  |  
  28. Ghosh, P. and C. Ghosh, 2009. Precipitation in interstitial free high strength steels. ISIJ Int., 49: 1080-1086.
    CrossRef  |  Direct Link  |  
  29. Haldar, A. and C. Ghosh, 2008. Microstructure and Texture Development in Warm Rolled High Strength IF Steels Containing Cu, P and B. In: Materials Processing and Texture, Rollett, A.D. (Ed.). Chapter 18, John Wiley and Sons Inc., Hoboken, NJ., USA., ISBN-13: 9780470408346, pp: 161-172.
  30. Ghosh, P., C. Ghosh, R.K. Ray and D. Bhattacharjee, 2008. Precipitation behavior and texture formation at different stages of processing in an interstitial free high strength steel. Scripta Mater., 59: 276-278.
    CrossRef  |  Direct Link  |  
  31. Ghosh, C., A. Haldar, P. Ghosh and R.K. Ray, 2008. Microstructure, texture, grain boundary characteristics and mechanical properties of a cold rolled and annealed martensitic steel. ISIJ Int., 48: 1626-1634.
    CrossRef  |  Direct Link  |  
  32. Ghosh, P., B. Bhattacharya and R.K. Ray, 2007. Comparative study of precipitation behavior and texture formation in cold rolled-batch annealed and cold rolled-continuous annealed interstitial free high strength steels. Scripta Mater., 56: 657-660.
    CrossRef  |  Direct Link  |  
  33. Bhattacharya, T., S. Mukherjee, D. Chakraborty, C. Ghosh and P.P. Sahoo, 2006. Investigation of a dissected petrol engine and transmission system with an aim to capture the recent advances and future trends of materials. Tata Search, 1: 1-13.
  34. Upadhyaya, A. and C. Ghosh, 2002. Effect of coating and activators on sintering of W-Cu alloys. Powder Metall. Progr., 2: 98-110.
  35. Ghosh, C. and A. Upadhyaya, 2002. Activated sintering of premixed and coated W-Cu alloys. Trans. Indian Inst. Met., 55: 535-542.
    Direct Link  |